Table of Contents
Advertisement
Connectors
Floppy Disk Connector: FDC
The series mainboard provides a standard floppy disk connector (FDC) that supports 360K, 720K
1.2M, 1.44M and 2.88M floppy diskettes. This connector supports the floppy drive ribbon ca
p
rovided in the packaging.
Hard Disk Connectors: IDE1-2/ SATA1-2
The series mainb
oard has a 32-bit Enhanced PCI IDE Controller that supports
Master, Ultra AT
A 33/ 66/ 100. This mainboard has two IDE connectors, IDE1 (
(secondary). It als
o provides two serial ATA connectors.
IDE1 (Prima
ry IDE Connector)
You can connect
up to two hard drives to IDE1. If you attach two drives, you
with three conn
ectors. You must also configure one drive as the master and one
using the jumper
s located on each drive.
IDE2 (Seco
ndary IDE Connector)
The IDE2 conn
ector can also support a Master and a Slave drive. The conf
IDE1. The second
drive on this controller must be set to slave mode.
SATA1/ SATA2
These SATA connectors support Serial ATA 150. These connectors only can connect to one serial
ATA hard disk each.
FDC
SATA1
BIOS
DIM M1
DI
M M2
DI
M M3
DIM M4
IDE2
IDE1
SATA2
16
PX875P PRO/ PX875P
PIO Mode 0~4, Bus
primary) and IDE2
must use a ribbon cable
drive as the slave,
iguration is similar to
S ocket 478
,
bles
Advertisement
Table of Contents
