Table of Contents
Advertisement
8-38 Removal and Replacement
Int •• ,al Per . . . . 1 Compute,
7.
Svat ••
V ROil Removal. To unlock the
ROM assembly, pullout the two black handles. Holding
onto the black handles, carefully pull the assembly out. Note that the bottom of the assembly is
keyed.
Flgur. 6-41. Removing the S,stem V ROM as.embly
R ••••• mbly Note:
To reinstall the ROM assembly in the computer, make sure that the assembly is
right-side
up
(the bottom of the assembly
is
keyed), then carefully plug
it
into the computer. Be careful
not to
bend the
connector pins.
Lock the ROM assembly in place, then reinstall the ROM door on the
back panel of the computer.
8.18.2 Disassembling the System V ROM Assembly
To disassemble the System V ROM Assembly, follow these steps:
1.
Remove the
ROM
assembly from the computer (refer to section
6.1~.1).
2. A tab at each corner of the bottom of the ROM case holds the cover on. To release the cover,
depress each tab in turn with a small flat-bladed screwdriver while pulling on the cover (see
figure
6-42).
Once the four tabs are released, remove the cover (making sure the black handles are
out).
Advertisement
Table of Contents
