Required Tools - HP Integral Personal Computer Service Manual

.. 2 ReMoval and ..... I_ ..... nt
I_,a' ..........
eo .....
uter
Observe the the following anti-static guidelines when working on the Integral PC:
• Use a static-safe workstation. At a repair bench, this may consist of a grounded anti-static work
surface (an anti-static mat), a grounded wrist
strap, a grounded soldering iron, and an ionized
air
blower directed over the workstation. At an on-site location, this may consist of a folding anti-static
mat, a grounded cable, and a wrist strap. Keep all insulators (such as coffee cups, paperwork, or
packing material) far away from static-sensitive devices. They are notorious static generators.
. • Keep all assemblies and components
in
their conductive packages until needed. When the part is
needed, unpack it only at a static-safe workstation and only while you are grounded. If you must
set the part somewhere, place it only on the conductive mat.
• Handle PC boards by the edges. Do
not touch any component, trace, or connector.
• Keep your clothing away from static-sensitive parts, even when using heel and wrist straps. The
static charge on clothing often is not bled away.
• Do not use erasers to clean contacts (they generate lotS of static and also tend to rub off the gold).
• Connect the chassis of the instrument you are working on to the grounded mat so that
it
will
remain grounded even when you remove the power cord for service. The ground jumper should
have a
I-MO
resistor built into
it.
to protect you in case of a ground fault in the instrument.
WAIINING
An anti-static wrist strap should have a I-MQ series resistor built into the ground jumper to
protect you against an electrical shock through the wrist strap. Use of an unapproved wrist strap
could result in a potentially fatal electric shock.
6.4 Required Tools
Table 6-1 lists the tools that you will need to disassemble and reassemble the computer.
Table
I-t.
R.qulred Tools
,..----------------------------------_
..
-
,._-
P~Num
... r
8710-1426
8710-1284
8710-1220
8710-0797
8730-0008
8710-1107
Description
Torx kit
T-IO angle driver
S.S-mm nut driver
'In-in. nut driver
Saewdriver, flat-blade
Pliers, needlenose
...
~