..... Remova. and Replacement
Integ,a. Per . . n •• Computer
3. Using needlenose pliers or a small screwdriver, remove the E-rings from the two small rocker pins
(see
figure 6-2).
Be careful not to drop the E-rings inside the case.
4. Disengage the bail arm from the pins and lift off the lid. Remove the spring washers from the
rocker pins to prevent loss.
Figure 1·2. Computer-Lid Rocker
If you need to disassemble the lid, see figure 9-6.
6.7 Removing the Logic A peA
To remove the logic A peA, follow these steps:
1. Remove the plug-in ROM assembly if one is installed (refer to section 6.16.1).
2.
Remove the back case (refer to section 6.5). Unsnap the white button on the clear
ESD
shield in
the upper right-hand corner (see figure 6-3).
.
•
••
I
Figure 8-3. Logic A Shield Screws