Table of Contents
Advertisement
13. Remove the printer switch panel as follows. Remove the screw shown in figUre 6-11, move the
front of the panel slightly to the right to clear the screw post, then lift the panel up and out.
'_lure 8-11. Printer Switch
Panel
14. Remove the two screws in the bottom of the printer assembly and the screw
in
the rear right-
hand corner of the assembly near the switch-panel tab slot. See figure 6-12. (You may have to
move the printhead out of the way to remove one of the screws.)
1 L Lift the printer assembly out of the unit being careful not to damage any of the cables .
•• ",),1.0
-
Flgu ... "12.
Printer Mountinl Scre.s
....... mlll'
Note.:
Make sure the tab on the ESD shield
is
back in place before reinstalling the
printer switch panel. The shield wraps up in a circular fashion around the bottom of the panel. Make
sure the dull side of the shield is toward the outside and faces the S.S-mm standoff (see figure 6-10).
To replace the printer switch panel, orient
it
properly, insert the tab into the slot at an angle, and drop
the panel into place. Install the screw (see figure 6-11).
Advertisement
Table of Contents
