Table of Contents
Advertisement
Remov.' and R ....
IIe . . . . . . . .
8-17
.llure 1-18 . . . iI-Arm Removal-Iprl,..
in
Outward Position
2.
Remove the TIO screw on the left end of the bail shaft.
3. Remove the E-ring on the right end of the bail shaft. Be careful not to lose the dowel when
removing the shaft from the bail arm.
4. Remove the two bail arms by removing the two E-rings.
To install the bail assembly, follow these steps:
1. When reassembling the bail assembly, be sure to note the left-and right-hand characteristics of
the bail arms. See figure 6-20.
Fllur.
1·20.
Ball-Arm and Spring Identification
Advertisement
Table of Contents
