Table of Contents
Advertisement
Integral ........
Computer
--
.
•
•
~
R ..... ow .. and Replaceme ..
t
8·21
....
'Igure 8-lab.
Displ.y-A . . .
mbl, Det.ils-8ack
2.
Lay the computer flat on
its
back.
3.
Position the display latch all the way to the
right. (You
may wish to hold it in place with
a
piece
of masking tape.)
4. Remove the rubber spacer.
L Connect the flex cable.
&. While holding the bottom of the display assembly up, insert the left-hand pivot into
its
hole in
the frame. Position the dash pot bracket in line with the slot in the frame, then lower the right side
of the display assembly so that the right-hand pivot rests in
its
pivot position and the dashpot
bracket extends through the slot. Now lower the bottom edge of the display assembly so that the
assembly
is
lying Oat
in
place
in
the frame. The panel spring should have folded down between
the display assembly and the frame. If
it
didn't, reach
in
with your finger and push it down.
7. Insert the rubber spacer (if not present),
its
arrow pointing up, into its hole in the frame to the
right
of the right-hand display pivot. The rubber spacer should cover half of the pivot. See figure
6-28a.
I. Install the pivot clamp.
I. Install the dashpot-bracket sa-ewe
10. Reset the spring force on the display latch by putting the free end of the spring back into its slot.
11. Stand the computer upright and install the disc-drive bezel. Press it until
it
snaps into place.
12. To
test
the dashpot, press the display latch to the
right. If
the dashpot
is
mounted properly, the
display assembly will swing up quickly at first and then more slowly.
Advertisement
Table of Contents
