HP Integral Personal Computer Service Manual page 61

.. 22 R .... ov.1 and Replacement Integra .......... 1
eo .....
u • .,
3.
Insert a small flat-blade screwdriver between the disk drive bezel and the front edge of the cable
well just to the right of the centerline of the bezel. It should contact the latch approximately
3/ 4 -
inch below the top edge of the bezel. See the figure 6-24.
,U=Ii
~.....
.,
......
. . . . -. . . "--.---t--------..
Figure 1-24. Disconnecting the Disc-Drive Beze.
4. Press down carefully with the screwdriver to disengage the latch and swing the bezel forward and
off. Remove the disc eject button.
S. Close the computer lid and latch it, then lay the computer flat on its back.
CAunON
If you proceed beyond this point with the computer in the upright position, the display-panel
assembly may fall out and be damaged.
I. Remove the hvo screws holding the pivot clamp directly above the disc drive and remove the
clamp. See figure 6-25.
DMhpot
.nlCket
Figure
8-25. The Pivot Clamp and D.shpot Bracket
Spri ...