Removing The Disc Drive - HP Integral Personal Computer Service Manual

• •• - . __ ... _ _ _ _ vv ............
.......
"...-
................
,.
Mo.. I"'ch
10pto lensorl
R.p •• c ...... t. To replace the home switch, follow these steps:
t.
Locate the home switch shown in figure 6-22 and remove the T6 screw that fastens the switch to
the mechanism frame.
. Figure 1-22. Ho .... Switch and Out-Gf.Pa,er Switch Loc.tlons
H ....
Switc:tI
2. Cut the
ti~
wrap holding the switch cable to the other cables and lift the switch out.
Out-o,·p .... '
Switch
llep"cement. To replace the out-of-paper switch, follow these steps:
1_ Locate the out-ai-paper switch shown in figure 6-22 and loosen the two T6 screws that hold the
switch on its bracket.
&.
Slide the switch free of the loosened screws, cut the tie wrap holding the switch wires to the other
cables, and lift the switch out.
6.1 0 Removing the Disc Drive
To remove the disc drive from the computer, follow these steps:
t _ Remove the back case (refer to section 6.5).
2. Disconnect the four-wire power cable and the flex cable from the back of the disc drive.