Table of Contents
Advertisement
Unpack the ceramic logs very carefully to avoid damaging their fragile material. Install the logs as shown below.
Please note that the position of the logs is critical to insure the good performance of the appliance.
1. Place the rear log centering it side to side in the
fi rebox. Pull it forward until it sits against the sheet
metal tabs behind the burner. The log will be
inclined forward.
Front log
support
Rear Log
against
sheet metal
tabs
2. Place the front left log on top of the burner with its
front edge resting slightly on the window frame.
3. Place the front right log on the top of the burner with
its left end abutted to the front left log and its front
edge resting slightly on the window frame.
Center the front logs side to side in relation to
the fi rebox.
Ceramic Logs Installation
4. Identify the right cross log; it has
5. Identify the middle cross log. It does not have a
6. Identify the left cross log; it has a hole under its
a hole under on of its end and it is
the shortest cross log. Place it on
the right pin located on the rear
log. Rest its other end in the crook
of the front right log.
hole underneath. Place its narrow end on the fl at
depression in the rear log next to the right cross log
on the rear log. Place its wider end on the front log.
narrow end. Place its narrow end on the pin located
on the rear log. Rest its wider end on the the crook in
the front left log at an angle of
approximately 30 degrees from
the center line of the fi replace to
allow for the fl ame to come up
in front of the rear log.
25
25
Hide quick links:
Advertisement
Table of Contents
