Framing - Valor Horizon 534ILN Installation And Operation Instructions Manual

• A non-combustible hearth is not necessary in front of this appliance.
• Note that the unit is installed at the framing stage and fi xed to framing using support angles. See page 20. Wall
fi nish is then installed over the support angles up to the black frame on the unit.
NOTE: If using a 613CCB front, refer to the kit's instruction manual for framing dimensions.
When the appliance is installed directly on carpeting, tile or other combustible material other than wood fl ooring, the
appliance shall be installed on a metal or wood panel extending the full width and depth of the appliance.
WARNING!
The 9" (23 cm) space
between the appliance
and the header MUST
be non-combustible
(cement board or
similar) when using
the 534HNK or
534HPK kits.
29-3/4" to wall finish
30-3/4" when using
645CFV Clearview Front
FRAMING DIMENSIONS
FRAMING IN A CORNER
10 10

Framing

Wall Finish
33-3/4" to
header
16" min. straight out or off the top venting.
Allow for elbow if rear vent with rise.
45-1/2" (115.5 cm) min.
1-1/2"
(38 mm)
min.
clearance
Header height MUST BE
38-3/4" when using
the 534HNK or
534HPK High Input kits!
This is the framing
width. Wall finish
to 32-3/16" wide.