Valor Horizon 534ILN Installation And Operation Instructions Manual page 32

Operation Modes
STANDBY MODE—Ignited pilot only.
MAN MODE —Manual Mode. You can use this mode to adjust the flame height up or down.
MAN
☼ TEMP MODE —Daytime Temperature Mode (appliance must be in Standby mode; pilot ignited): The room temper-
TEMP
ature is measured and compared to the set temperature. The flame height is then automatically adjusted to achieve the
Daytime set temperature.
☽
TEMP MODE—Nighttime Setback Temperature Mode (appliance must be in Standby mode, pilot ignited): The room
TEMP
temperature is measured and compared to the Nighttime Setback temperature. The fl ame height is then automatically
adjusted to achieve the Nighttime Setback temperature.
TIMER MODE—(appliance must be in Standby mode, pilot ignited): The Timer setting allows you to set two burner
TIMER
ON times and two burner OFF times for every 24-hour period.
Scrolling through modes and functions
Briefly pressing the SET button changes the operation sequences in the following order:
MAN
NOTE: MAN mode can also be reached by pressing either the
Flame Height
The flame height can be adjusted in the following manners. In MANUAL mode,
1. Press the
2. Press the
3. Press the
For fine adjustments, tap the
NOTE: While pressing either button, a symbol indicating transmission appears on the upper right
hand corner of the display. The receiver confirms transmission with an acoustic signal.
Time
To set the time, follow the steps below.
1. The display indicates °C/24-hour or °F/12-hour clock. To change from one to the other, press
2. To set the time, hold down both the
3. Quickly press the
4. Press the OFF button to return to manual mode or simply wait and it will automatically return to
32 32
Remote Control Operation
→ →
☼ ☽
TEMP TEMP
☼
Mode Sun
Daytime temperature setting
TEMP
Start time setting
TIMER
(large flame) button to turn on the main burner.
(large flame) button to increase the flame height.
(small flame) button to decrease the flame height or to go to pilot Standby position.
and hold both the OFF and
button to set the hour and the
Note: You must start setting the time while the display is fl ashing. If it stops fl ashing, go back to 2.
Manual mode.
hours
→ →
and back to
TIMER
Moon
Nighttime temperature setting
Stop time setting
and buttons.
buttons until the display changes.
and buttons until the display fl ashes. Let go.
minutes
.
MAN
or buttons.
☽
button to set the minutes.