Ceramic Fuel Bed Installation; Ceramic Walls Installation; Ceramic Logs Installation - Valor 534 XAN Installation And Owner's Manual

12.1 Ceramic Walls Installation

1. Locate the ceramic rear wall
in the channel at back of the
firebox and flat against the
back of the firebox. See
figure 41.
2. Locate the sidewalls against
the sides of the firebox.
Make sure that they are
behind the raised edges of
the burner module base at
the back corners. See figure
42.
3. Remove two screws from
under the top front of the
firebox. Using these screws
fit the port cover. See figure
43.

12.2 Ceramic Logs Installation

1. Place the ash bed in
position. The
projections at the
front of the ash bed
locate against the
sloping metal stops
immediately behind
the burner. See figure
44.
2. Place the rear log in
position locating the
two pins in the top of
wedge into the holes
in the rear log. See
figure 45.
3. Place the front log at
the front of the
firebox as shown in
figure 46.
4. Place the right side
center log in position
locating it on the two
locating pins on the left hand side of the ash bed with its "nose" resting at the center of
the ash bed as shown in figure 47.
5. Place the right side center log in position locating on the two pins on the right hand side
of the ash bed with its nose" resting at the center of the ash bed as shown in figure 48.
6. Place "branch end" of the cross log on the pin located on the center of the rear log and
the other end in the locating pocket on the left side of the front log as shown in figure
49.

12. CERAMIC FUEL BED INSTALLATION

Figure 41 Rear wall
Figure 44 Ash bed
Figure 42 Side walls
Figure 45 Rear log
28
Figure 43 Port cover
Figure 46 Front log
Figure 47 left centre log
Figure 48 right centre log
Figure 49 Cross log