Remote Control Operation - Valor Horizon 534ILN Installation And Operation Instructions Manual

NOTE: Before using the remote control system for the fi rst time, the receiver and the handset must be
synchronized. See the section Remote Control Initial Set-up on page 26 in this manual.
Your fi replace remote control helps you get the comfort, convenience and aesthetics you want from your gas fi replace.
The remote controls your fi replace in different ways.
IMPORTANT: BEFORE YOU BEGIN, please note that on this system, the settings of time, temperature and automatic
ON/OFF can only be programmed when the function display is fl ashing. Be patient when programming as it can take
a few seconds to set.
Current
temperature
(F or C)
Period
start or end
(Temp, Timer)
Current
programmed
period (Timer)
Display Overview
Note: In the TEMP or TIMER modes, the remote
handset senses the room temperature and adjusts the
fl ame accordingly.
To communicate, the handset should be within 15 feet
(4.5 meters) of the fi replace.
Do not leave the handset on the mantel or hearth.
Turning your fi replace ON
IMPORTANT: When the pilot is lit, the valve motor
turns automatically to maximum fl ame height.
1. Make sure that the MAN knob on the valve is in ON position.
2. Make sure that the switch on the valve is in the I position.
3. Press and hold the OFF and
The acoustic signals will continue until the pilot lights. The remote control will go automatically into
TEMP mode. The fl ame will be at maximum height until the remote control reads the temperature
(factory set) and will then adjust the fl ame accordingly.
You can put the remote in MAN manual mode, change the temperature in TEMP mode or
program your remote in TIMER mode as indicated in the following sections.
Turning your fi replace OFF
1. Press the
2. Press the OFF button to turn the pilot off.
Alternately, you can press the O button on the switch if you won't use your fi replace for a long
period of time, if you cannot locate your remote control handset or if you wish to change the
batteries.

Remote Control Operation

Handset
sensor
Battery status
Current time
(12 or 24 hour clock)
Modes (Manual,
Temperature, Timer)
Release the buttons.
(small fl ame) button to reduce the fl ame to pilot.
Set (scrolls
through
modes and
settings)
OFF (returns
to set mode,
turns the burner
and the pilot off )
Handset Overview
(large fl ame) buttons until you hear a short acoustic signal.
Large flame
button (flames
up, sets hours,
temperature)
Small flame
button (flames
down and off,
sets minutes,
temperature)
31 31