Ceramic Logs Installation - Valor 1200EAN (NG) Installation And Owner's Manual

The ceramic logs are supplied in two packages. Unpack them very carefully to avoid damaging the fragile
material. Install the logs as shown below. Please note that the position of the Logs is critical to insure proper
performance of the appliance.
1. Place the Rear Log on the rear log support behind the burner. Pull log forward until it contacts at ends. See
detailed view.
Pins for Top Left and Right Logs
2. Place the Middle Log on the pins of the middle log support on the burner. Move the log slightly forward so it sits
against the front tabs of the log support. See detailed view.
Pins for Middle Left and Right Logs
3. Place the Front Log behind the grate with its rear
right notch on the middle log's support front tab. The
log must also be fl at against the burner plate. See
detailed views.

Ceramic Logs Installation

QUALIFIED
INSTALLER
Touches
here
Rear Log position
against the back of
middle log support
Middle Log position
on pins at each end
Notch in back
side of log lines
up with bracket
Front Log bottom
should contact
sheet metal below
39