Temperature
Use this setting when you come in and want to enjoy a set temperature.
1. Select either the ☼
2. Hold the SET button until the TEMP display flashes.
3. Set the desired temperature with the
4. Press the OFF button or simply wait and the display will go to the temperature control mode.
5. The display must remain in TEMP mode on the remote handset.
Timer
It is possible to program two periods of time per day at which your fi replace will turn on and off
automatically.
For example, you can set your fi replace to turn on in the morning just before you get up (P1
[
start time
fi replace to turn on again at the end of the day (P2
bed at night (P2 ☽ [stop time]).
If you wish to set only one time period at which your fi replace will turn on and off, program P2
[
start time
1. Select TIMER mode by briefly pressing the SET button.
2. Press and hold the SET button until TIMER is displayed on the lower right hand side.
3. Press and hold the SET button until P1 ☼ and the time display flashes. Set the start time by
4. Briefly press the SET button again for the next burner cycle time, which will be P2
5. Once all four times are set, press OFF or simply wait to complete programming.
6. The remote handset must remain in TIMER mode to function automatically.
Timer Programming Example (default temperatures shown)
6:00 a.m.—
☼
P1
Start time
☼
Set temp
74˚F
Remote Control Operation
MODE or the ☽
TEMP
Note: 4.5°C/40°F is the minimum temperature setting.
Note: If you would like the Nighttime Setback temperature control to turn off, decrease the
☽
MODE setting until [---] appears on the display.
TEMP
Your fi replace will reach the set temperatures and the remote handset will check the tempera-
ture every fi ve minutes, adjusting the amount of fuel needed to give you a steady, even heat.
])
and to turn off when you leave for the day
and P2 ☽ [stop time] for the same time as P1 ☽ [stop time].
]
pressing the
button for the hour and the
to P1 ☽ and set the stop time in the same manner you just set P1 ☼.
hours
9:00 a.m.—
☽
P1
End time
☽
Set temp
40˚F
MODE by briefly pressing the SET button.
TEMP
or the
buttons.
(
☼ [
start time
button for the minutes. Then, briefly press SET
minutes
5:00 p.m.—
☼
P2
Start time
☼
Set temp
P1 ☽ [stop time]). Then, you can set your
])
and to turn off when you go to
9:00 p.m.—
☽
P2
End time
74˚F
Set temp
☼
☼
P2 ☽.
☼ and
6:00 a.m.—
☼
P1
Start time
☽
40˚F
33
33