Chapter 5
Voltage Configuration
Eaton 5115 Tower UPS (500–1400 VA) User's Guide
Additional UPS Features
This section describes:
S
Voltage configuration
S
USB and DB-9 communication ports
S
Network transient protector
The DIP switches on the rear panel of each unit (see Figure 16) are used
to configure the output voltage and input voltage range.
To configure voltage:
1.
The UPS must be completely shutdown.
To turn off the UPS, press and hold the
and then unplug the UPS from the power outlet.
2.
Set the DIP switches according to the configurations in Table 1.
3.
Plug the UPS power cord into a power outlet.
4.
Press and hold the
(approximately two seconds) to turn the UPS on.
button until you hear the UPS beep
UPS Rear Panel
Figure 16. DIP Switches
S
05146640 Rev D www.eaton.com/powerquality
button for two seconds
2
1
OFF
ON
35