Ups Front Panel; Initiating The Self-Test - Eaton 5115 User Manual

UPS Front Panel

Initiating the Self‐Test
Eaton 5115 Tower UPS (500–1400 VA) User's Guide
The UPS front panel indicates the UPS status and also identifies
potential power problems. Figure 15 shows the UPS front panel
indicators and controls.
If the alarm beeps or a UPS alarm indicator stays on, see Table 10 on
page 52 to identify and correct the problem.
NOTE The batteries must be fully charged and the UPS must not be in Battery mode to
perform the self‐test.
Press and hold the
During the five-second test, the bar graph indicators cycle through twice.
If the alarm beeps or a UPS alarm indicator stays on, see
"Troubleshooting" on page 51.
On/Off Button
Test/Alarm Reset Button
Power On Indicator (green)
On Battery Indicator (yellow)
Overload Indicator (red)
Service Indicator (red)
Figure 15. UPS Front Panel
button for three seconds to initiate the self‐test.
S 05146640 Rev D www.eaton.com/powerquality
OPERATION
33