Eaton 5115 User Manual page 60

TROUBLESHOOTING
Table 10. Troubleshooting Guide (continued)
Alarm or Condition
3 beeps every 10
seconds.
Continuous beep.
Continuous beep.
54
Eaton 5115 Tower UPS (500–1400 VA) User's Guide
Possible Cause
Failed attempt to start the
UPS on battery.
The output wave is
abnormal while the UPS is
on battery.
The output voltage is
below or above the limit
while the UPS is on
battery.
S 05146640 Rev D www.eaton.com/powerquality
Action
Plug the UPS into a power outlet for 24 hours to
charge the battery. After charging the battery, press
and hold the button for 3 seconds; then check
the indicator.
If the indicator still flashes, see "Replacing
Batteries" on page 40.
Shutdown is imminent. Save your work and turn off
your equipment. Turn off the UPS. Contact your
service representative.
Save your work and turn off your equipment. Turn off
the UPS. Contact your service representative.