Additional Ups Features; X-Slot Cards - Eaton 5125 User Manual

Chapter 5

X-Slot Cards

Eaton 5125 Tower UPS (1000–2200 VA) User's Guide

Additional UPS Features

This section describes:
S
X-Slot cards
S
Network transient protector
S
Load segments
X-Slot cards allow the UPS to communicate in a variety of networking
environments and with different types of devices. The Eaton 5125 is
factory-installed with a Single-Port Card, which can be replaced with one
of the following X-Slot cards:
S
t
ConnectUPS -X Web/SNMP Card - has SNMP and HTTP capabilities
as well as monitoring through a Web browser interface; connects to a
twisted-pair Ethernet (10/100BaseT) network. It has a built-in
switching hub that allows three additional network devices to be
connected to the network without the requirement of additional
network drops. In addition, a Environmental Monitoring Probe can be
attached to obtain humidity, temperature, smoke alarm, and security
information.
S
Relay Interface Card - has isolated dry contact (Form-C) relay outputs
for UPS status: Utility failure, Low battery, UPS alarm/OK, or On
bypass.
S
Modbus Card - allows you to continuously and reliably monitor the
®
UPSs in your Building Management System (BMS).
S
Multi-Server Card - has six serial communication ports that can
communicate simultaneously with other computers using LanSafe
Power Management Software (provided on the Software Suite CD).
S
USB Card - connects to a USB port on your computer.
S 05147304 Rev C www.eaton.com/powerquality
®
35