Eaton 5115 User Manual page 31

5. Plug the equipment to be protected into the UPS output
receptacles.
NOTE DO NOT protect laser printers with the UPS because of the exceptionally high power
requirements of the heating elements.
6. Press and hold the
(approximately two seconds).
The
your equipment. The UPS conducts a self‐test and enters Normal
mode.
If the alarm beeps or a UPS alarm indicator stays on, see Table 10
on page 52.
NOTE The batteries charge to 90% capacity in approximately 3 hours. However, it is
recommended that the batteries charge for 6 to 24 hours after installation or long-term
storage.
Eaton 5115 Tower UPS (500–1400 VA) User's Guide
button until you hear the UPS beep

indicator illuminates indicating that power is available to
S 05146640 Rev D www.eaton.com/powerquality
INSTALLATION
25