Users Safety Summary - Tektronix Phaser 740 Service Manual

Users safety summary

Terms in CAUTION
manual:
WARNING
Power source:
For 110 VAC printers, Do not apply more than 130 volts RMS between
the supply conductors or between either supply conductor and ground. Use only the
specified power cord and connector. For 220 VAC printers, Do not apply more than
250 volts RMS between the supply conductors or between either supply conductor
and ground. Use only the specified power cord and connector.Refer to a qualified
service technician for changes to the cord or connector.
Operation of product:
to replace fuses inside the product. Do not operate without the covers and panels
properly installed. Do not operate in an atmosphere of explosive gases.
WARNING
not de-energize the printer. You must remove the power cord to
disconnect the printer from the mains. Keep the power cord
accessible for removal in case of an emergency.
Safety instructions:
product into a power source.
Terms on
CAUTION
product:
apparent. For example, a panel may cover the hazardous area.
Also applies to a hazard to property including the product itself.
DANGER
Care of product: Disconnect the power plug by pulling the plug, not the cord.
Disconnect the power plug if the power cord or plug is frayed or otherwise damaged,
if you spill anything into the case, if product is exposed to any excess moisture, if
product is dropped or damaged, if you suspect that the product needs servicing or
repair, and whenever you clean the product.
Ground the product:
grounded AC outlets only. If necessary, contact a licensed electrician to install a
properly grounded outlet.
Conditions that can result in damage to the product.
Conditions that can result in personal injury
or loss of life.
Avoid electric shock by contacting a qualified service technician
Turning the power off using the On/Off switch does
Read all installation instructions carefully before you plug the
A personal injury hazard exists that may not be
A personal injury hazard exists in the area where
you see the sign.
Plug the three-wire power cord (with grounding prong) into