MyBinding Standard APC45 Programmable Instruction Manual page 35

3-6 Creating a Cutting Program (Correct)
Show the step 3 to correct.
Ent
- Press the key for the step 1 which will
not be corrected.
- Repeat the same procedure and move to step 3.
Correct the value of the step 3.
C
- Press the key to cleat the old value
"249.5", input the new value "250" and press
Ent
the key.
Save the program.
Ent
- Press the key on the confirmation
screen to the right and finish the correction of
the program.
- The program cutting mode of the course num-
ber 5 starts and the LED of the
ton is illuminated.
When the
gauge moves to the position of the step.
When the
next step appears.
Repeat this and move to the step 3.
COURSE : 5
2 : 260.0 3: 249.5
COURSE : 5
3: 250.0 4 : 270.0
COURSE : 5
10 : 130.0
EXIT?
Y : "Ent"
but-
MEMORIZE?
Y : "Ent"
COURSE : 5
1
:420.0
The program of the course
number 5 starts.
Ent
key is pressed, the back-
Ent
key is pressed again, the
3 /10
C
Press the key and
clear the old
"249.5."
After the new value
"250" is input and the
Ent
key is pressed,
the value for the step 4
is ready to be input.
Ent
Press the
4 /10
and move to the next
step, and repeat this
procedure.
When "0" is input in the
11/10
last step 11 and
1 1: 0
Ent
key is pressed,
The exit confirmation
screen appears.
N : "C"
Ent
When the key is pressed,
The memory confirma-
tion screen appears.
N : "C"
Ent
When the key is pressed,
1/10
2
:260.0
value
key
the
27