Check The Foot Pedal - MyBinding Standard APC45 Programmable Instruction Manual

2-5 Check the Foot Pedal

In the following steps, if the machine does not
operate as explained "the machine is OK",
stop the check immediately.
The foot pedal is used for the following pur-
pose.
1. To check the cutting position
The cutting position can be checked before
actual cut by stepping on the foot pedal and
lowering the clamp.
2. Sheet Press
Swelled or curled sheets can be cut more
accurately by stepping on the foot pedal and
pressing them by the clamp. (The sheets can
be cut by pressing the cutting buttons while
stepping on the foot pedal.)
Step on the foot pedal slowly.
- If the clamp lowers smoothly, the machine is
OK.
Do not get on, or step on the foot
pedal with great force. The machine
may be damaged.
Release the foot pedal.
- If the clamp lifts to the upper limit, the machine
is OK.
10
CAUTION