MyBinding Standard APC45 Programmable Instruction Manual page 32

3-6 Creating a Cutting Program (Input)
Input the cutting length for the step 1.
- In this step, the cutting length of the step 1
should be 320.0 for example.
3
- Press the
numeric keypad. The backgauge moves to
the position of 320.0.
- Check that the current position of the back-
gauge is "320.0" and press the
again.
- The step 1 is set and the step 2 is ready to be
input.
When the value for the
step 1 is input as 320, the
backgauge moves to the
position of 320.0.
When the
pressed again,
COURSE14
1 : 3 20 . 0
If the value after the decimal point is "0",
the decimal point and "0" is not neces-
sary to be input.
24
2 0 Ent
keys on the
Ent
key
Ent
key is
The value for
the step 2 is
2 / 0
ready to be
2 : 0
input.
Input the cutting length for the step 2.
- In this step, the cutting length of the step 2
should be 280.0 for example.
2 8
- Press the
numeric keypad. The backgauge moves to
the position of 280.0.
- Check that the current position of the back-
gauge is "280.0" and press the
again. The step 3 is ready to be input.
COURSE14
2 / 0
1 : 320.0 2 : 0
When the 280 is input in
the step 2,
COURSE14
2 / 0
1 : 320.0 2 : 2 8 0 . 0
And when the
pressed again,
COURSE14
3 / 0
2 : 280.0 3 : 0
Input the cutting length for the step
3 or after as well.
- In the following procedures, the last process
should be step 13 for example.
If the value for the step 3
or after is input,
COURSE14
COURSE14
14
14
14
COURSE14
12 : 100.0
0 Ent
keys on the
Ent
key
The value for
the step 2 is
ready to be
input.
Ent
key is
The value for
the step 3 is
ready to be
input.
appear.
0
4
4
0
0
0
13 / 0
1 3 : 0