Manual Inputting Of A Gps Location (Lat/Lon) - Standard Horizon Matrix GX2000 Owner's Manual

11.10 MANUAL INPUTTING OF THE GPS LOCATION ( LAT/LON )
You may send the Latitude/Longitude of your vessel manually even if the
GX2000/GX2100 is not connected the GPS receiver unit.
After the position is entered, transmitting a DSC Distress, Position Request, or
Position Send will contain the manually entered position.
1. Press and hold down the [ CALL ( MENU )] key
until "Setup Menu Setup Menu" appears.
Setup Menu Setup Menu
Setup Menu
2. Rotate the CHANNEL knob to select "DSC
SETUP" menu.
SETUP SETUP
SETUP SETUP
3. Press the [ SELECT ] soft key, then select "PO-
SITION INPUT" with the CHANNEL knob.
SITION INPUT SITION INPUT
SITION INPUT SITION INPUT
4. Press the [ SELECT ] soft key. The transceiver
will beep, and the display will be as shown in
the illustration on the right.
5. Enter the latitude/longitude of your vessel and your
local UTC time in the 24-hour notation by the CHAN-
NEL knob. Rotate the CHANNEL knob to select the
number and press the [ ENT ] soft key to move the
cursor to the next character. You may backspace
the cursor by pressing the [ BACK ] soft key, if you
make a mistake.
6. To store the data entered, press and hold the [ ENT ] soft key.
7. Press the [ QUIT ] soft key several times to return to radio operation.
GX2000/GX2100
DSC DSC
DSC DSC
PO- PO- PO- PO-
Page 71