Optional Cmp30 (Ram3) Installation - Standard Horizon Matrix GX2000 Owner's Manual

8.10 OPTIONAL CMP30 ( RAM3 ) INSTALLATION
The GX2000/GX2100 is capable of using a CMP30 ( RAM3 ) Remote Station
Microphone to remotely control the Radio, AIS, DSC and PA/Fog functions. In
addition the GX2000/GX2100 can operate as a full function intercom system.
1. Connect the Extension Cable to the Remote Mic eight pin connector on
the rear panel, then tighten the Cable Nut (see illustration below).
2. Referring to illustration below, make a 1.2" (30 mm) hole in the wall, then
insert the Extension Cable into this hole. Connect the Gasket and Mount
Base to the Extension Cable Connector using the Nut.
3. Drill the four Screw holes (approx. 2 mm) on the wall, then install the Mount-
ing Base to the wall using four screws.
4. Put the Rubber Cap on to the Nut. The installation is now complete.
The routing cable can be cut and spliced, however care needs to be
taken when reconnecting the wires to ensure water integrity.
Before cutting the cable make sure it is not plugged into the radio. After
cutting you will notice there are the following wires:
Yellow, Green, Brown, Purple, Blue, Green, Red , Shield
The red and shield wires are wrapped in foil. Remove the foil, and
seperate the Red and shield wires.
Page 26
NOTE
Wall
Routing Cable
External Speaker Connections
Gasket
Mounting Bracket
Nut
GX2000/GX2100
Cap