Manual Inputting Of The Gps Location (Lat/Lon) - Standard Horizon MATRIX GX3000S Owner's Manual

14.4 MANUAL INPUTTING OF THE GPS LOCATION ( LAT/LON )
You may send the Latitude/Longitude of your vessel manually from the VH-310
Handset even if the GX3000S is not connected the GPS receiver unit.
After the position is entered, transmitting a DSC Distress, Position Request, or
Position Send will contain the manually entered position.
1. Press and hold down the [ CALL ( MENU )] key until "
Setup
" menu appears.
2. Press the [ ] key to select "
3. Press the [ ENT ] key, then select "
[ ] key.
4. Press the [ ENT ] key then, enter the your local time from the
keypad by the 24-hour system on the UTC time.
5. Enter the Latitude of your vessel location (xx.xx.xx) by the
keypad, then press the [ 6 ( NAV )] key to select North (N), or
[ 7 ( SCRM )] key to select South (S).
6. Enter the Longitude of your vessel location (xxx.xx.xx) by
the keypad, then press the [ 3 ( SCAN )] to select East (E), or
[ 9 ( FOG )] key to select West (W).
7. If a number was entered by mistake, press the H/L key re-
peatedly to select the number. Press the [ ] / [ ] key to se-
lect the desired number.
8. Press and hold in the [ ENT ] key to store the data entered,
then press the [ 16/9 ] key to exit this menu and return to
radio operation mode.
Page 80
DSC SETUP " menu.
POS INPUT
Radio
" with the [ ] /
GX3000S