Manual Inputting Of The Gps Location (Lat/Lon) - Standard Horizon Eclipse DSC+ GX1100S Owner's Manual

11.11 MANUAL INPUTTING OF THE GPS LOCATION ( LAT/LON )
You may send the Latitude/Longitude of your vessel manually even if the
GX1100S is not connected the GPS receiver unit.
After the position is entered, transmitting a DSC Distress, Position Request, or
Position Send will contain the manually entered position.
1. Press and hold down the [ CALL ( MENU )]
key until "SETUP MENU SETUP MENU" appears.
SETUP MENU SETUP MENU
SETUP MENU
2. Press the [ ( UP )] / [ ( DOWN )] keys to se-
lect "POS INPUT POS INPUT" menu.
POS INPUT POS INPUT
POS INPUT
3. Press the [ ENT ] key. The transceiver will beep,
and the display will be as shown in the illustration
on the right.
4. Enter the time in 24 hour format on the UTC
time. Use the [ ENT ] and the microphone's
[ H/L ] key to navigate to each column of the
time, then use the [ ( UP )] / [ ( DOWN )]
keys to select the desired numbers in each
colum. Repeat for each column, to complete
the time.
5. Enter the Latitude/Longitude of your vessel
location with the same procedure as de-
scription above.
6. To store the data entered, press the [ ENT ] key. To
exit this menu and return to radio mode press the
[ 16/9 ] key.
Page 56 GX1100S