Receiving A Dsc Position Report Call - Standard Horizon Matrix GX2000 Owner's Manual

11.9.3 Receiving a DSC Position Report Call

When another vessel transmits their vessels location to the GX2000/GX2100
the following will happen:
1. A ringing sound will be produced when the call is
received.
2. Press the [ CLR ( WX )] key to stop ringing.
3. Rotate the CHANNEL knob to see position infor-
mation of the station.
4. To exit to radio mode, press the [ QUIT ] soft key.
11.9.4 Navigating to a received Position Report call
1. If you wish to display the received vessel on the
"WAYPOINT" screen, go to next step, if you wish to
only save the received vessel, go to step 9, other-
wise press the [ QUIT ] soft key to return to radio op-
eration.
2. Press the [ TO WPT ] soft key to enter the "Waypoint Input
the desired waypoint name (up to 11 characteres),
described previously (select the letter/number by ro-
tating the CHANNEL knob and move the cursor by
pressing the [ ENT ] / [ BACK ] soft key).
3. You may change the "ID", if desired.
4. When you are finished entering the waypoint name, press and hold the
[ ENT ] soft key to show the "WAYPOINT" Screen.
The display indicates the distance and direction of
the received vessel, and also the compass indicates
the received vessel by dot ( ) .
5. To stop navigation and return to the radio mode:
1) Press and hold down the [ CALL ( MENU )] key until "Setup Menu
pears.
2) Press the [ SELECT ] soft key, then select "GENERAL SETUP
CHANNEL knob.
3) Press the [ SELECT ] soft key, then select "NORMAL
knob.
4) Press the [ SELECT ] soft key to return to radio operation.
Page 70
Waypoint Input" menu, then enter
Waypoint Input Waypoint Input
Waypoint Input
Setup Menu" ap-
Setup Menu Setup Menu
Setup Menu
GENERAL SETUP" with the
GENERAL SETUP GENERAL SETUP GENERAL SETUP
NORMAL" with the CHANNEL
NORMAL NORMAL
NORMAL
GX2000/GX2100