Manual Inputting Of The Gps Location (Lat/Lon) - Standard Horizon QUANTUM Series GX3500S Owner's Manual

11.9 MANUAL INPUTTING OF THE GPS LOCATION ( LAT/LON )
You may send the Latitude/Longitude of your vessel manually even if the
GX3500S is not connected the GPS receiver unit.
After the position is entered, transmitting a DSC Distress, Position Request, or
Position Send will contain the manually entered position.
1. Press and hold down the [ CALL ( MENU )] key until
Radio Setup
"
2. Turn the CHANNEL selector knob to select "
Setup
" menu.
3. Press the [ ENT ] key, then select "
the CHANNEL selector knob.
4. Press the [ ENT ] key. The transceiver will beep, and
the display will be as shown in the illustration on the
right.
5. Enter the your local time from the keypad by the 24-
hour system on the UTC time, then press the [ ENT ]
key.
6. Enter the Latitude/Longitude of your vessel location
by the keypad, then press the [ ENT ] key. To select
North (N) press [ 6 ( NAV )] key, South (S) press the
[ 7 ( SCRM )] key, East (E) press the [ 3 ( SCAN )] key or
West (W) press the [ 9 ( FOG )] key.
7. To store the data entered, press the [ 16/9 ] key to exit
this menu and return to radio operation mode.
GX3500S
" menu appears.
DSC
POS Input
" with
Page 59