Manual Inputting Of The Gps Location Lat/Lon - Standard Horizon GX2000E Owner's Manual

9.10 MANUAL INPUTTING OF THE GPS LOCATION LAT/LON

You may send the Latitude/Longitude of your vessel manually even if the
GX2000E/GX2100E is not connected the GPS receiver unit.
After the position is entered, transmitting a DSC Distress, Position Request, or
Position Report will contain the manually entered position.
1. Press and hold down the [ CALL ( MENU )] key
until "Setup Menu" appears.
2. Rotate the CHANNEL knob to select "DSC
SETUP" menu.
3. Press the [ SELECT ] soft key, then select "PO-
SITION INPUT" with the CHANNEL knob.
4. Press the [ SELECT ] soft key. The transceiver
will beep, and the display will be as shown in
the illustration on the right.
5. Enter the latitude/longitude of your vessel and your
local UTC time in the 24-hour notation by the CHAN-
NEL knob. Rotate the CHANNEL knob to select the
number and press the [ ENT ] soft key to move the
cursor to the next character. You may backspace
the cursor by pressing the [ BACK ] soft key, if you
make a mistake.
6. To store the data entered, press and hold the [ ENT ] soft key.
7. Press the [ QUIT ] soft key several times to return to radio operation.
Page 74 GX2000E/GX2100E