Manual Inputting Of The Gps Location (Lat/Lon) - Standard Horizon Matrix GX3000E Owner's Manual

11.4 MANUAL INPUTTING OF THE GPS LOCATION ( LAT/LON )
You may send the Latitude/Longitude of your vessel manually from the RAM+
Mic even if the GX3000E is not connected the GPS receiver unit.
After the position is entered, transmitting a DSC Distress, Position Request, or
Position Send will contain the manually entered position.
1. Press and hold down the [ CALL ( ENT )] key until "
Setup
" menu appears.
2. Press the [ ] key to select "
3. Press the [ CALL ( ENT )] key, then select "
the [ ] / [ ] key.
4. Press the [ CALL ( ENT )] key then, enter the your local time
by the 24-hour system on the UTC time. Use the
[ CALL ( ENT )] and [ H/L ] key to navigate to each column of
the time, then use the [ ] / [ ] key to select the desired num-
bers in colum. Repeat for each colum, to completed the time.
5. Enter the Latitude/Longitude of your vessel location with the
same procedure as description above.
6. Press and hold in the [ ENT ] key to store the data entered,
then press the [ 16/9 ] key to exit this menu and return to
radio operation mode.
GX3000E
DSC SETUP
" menu.
POS INPUT
Radio
" with
Page 75