Table of Contents
Advertisement
3-5 DMC Editing
5
Press the PLAYER/DMC button
and set the IN point for the player
unit.
Note
You cannot set an OUT point for
the player unit.
6
Set the initial playback speed by
rotating the shuttle dial while
holding down the PLAYER/DMC
button together with the ENTRY/
SHIFT button.
If you wish to set the initial speed
to normal speed, press the PLAY
button.
The set speed is shown in the
submenu screen.
7
Once the initial speed has been
set, release the PLAYER/DMC
button and ENTRY/SHIFT
button.
8
Press the PREVIEW button.
The tape is prerolled. The recorder
side tape runs at normal speed and
the player side tape runs at its
initial speed.
9
When the search button starts to
flash, indicating that the tape has
reached the IN point, rotate the
shuttle dial to the position
corresponding to the desired
playback speed.
The variations in playback speed
are stored into memory while the
search button is flashing.
When the tape passes the OUT
point, the search button goes out.
3-16
Editing
If the JOG/SHUTTLE indicator
goes out before the tape passes
the OUT point
The unit cannot store any more
variations in playback speed. The
capacity of the playback speed
memory is 120 seconds.
3-5-3 Executing DMC
editing
Press the AUTO EDIT button.
DMC edit is executed at the playback
speed(s) stored in memory.
Once the DMC edit has been
completed, the playback speed(s) in
memory are cleared.
To confirm the results of the edit
Press the REVIEW button.
Note
When using the RM-450 or PVE-500
to perform DMC editing, setting the
initial speed to –1 may cause deviation
of the editing points by about 10
frames.
Advertisement
Table of Contents
