Table of Contents
Advertisement
4
Select the digit to set by rotating
the jog dial.
The flashing digit changes to the
digit on the right when you rotate
the jog dial clockwise, and to the
digit on the left when you rotate it
counterclockwise.
5
Set the value for the flashing digit
by rotating the jog dial while
pressing the search button.
6
Repeat steps 4 and 5 until you
finish setting all digits.
7
Press the SET button.
If the F-RUN/R-RUN switch is
set to F-RUN, the timecode starts
to advance immediately.
To set timecode to the
current time
1
Set the F-RUN/R-RUN switch to
F-RUN and the DF/NDF in the
submenu to DF (in 525 mode
only) (see page 2-32).
2
Carry out steps 1 to 6 of "To set
an initial timecode value" to set
the timecode to a time slightly
ahead of the current time.
3
Press the SET button at the instant
when the current time matches the
displayed timecode.
To set user bits
You can record up to 8 hexadecimal
digits of information (date, time, event
number, etc.) in the timecode track.
Proceed as follows.
1
Press the CTL/TC/U-BIT button
and select U-BIT.
2
Carry out steps 2 to 7 of "To set
an initial timecode value".
Settings are made in hexadecimal
(0, 1, 2,... 8, 9, A, B,... E, F).
You can record ID codes in user
bits. For details, see setup menu
items 603 and 604 (page 6-22).
1
2-15
Preparations
Advertisement
Table of Contents
