Table of Contents
Advertisement
AUDIO CH-1 to CH-4 buttons:
Select the audio signals of
channels 1 to 4 (multiple
selections possible).
TC button: Selects the timecode
signal.
3 TRIM/GOOD SHOT buttons
Press the TRIM+/MARK or TRIM –/
LIST button while pressing the IN/
OUT buttons 5 or AUDIO IN button
0 to adjust edit points in unit of 1
frame. The TRIM +/MARK button
advances 1 frame, and the TRIM –/
LIST button returns 1 frame.
When using a tape on which shot
marks have been recorded, you can
press the TRIM –/LIST button
together with the FWD or REW
button to read shot marks from the
tape, and you can press the TRIM +/
MARK button together with the FWD
or REW button to cue up shot mark
positions.
For details, see Chapter 5 "Shot
Mark/Shot Data".
4 ENTRY/SHIFT button
Press together with the IN button, the
OUT button, or the AUDIO IN button
to set edit points. The buttons for the
edit points that you set light.
Pressing this button together with a
button with two functions, such as the
PLAYER/DMC button or the REC/
SEQ button, selects the function
indicated in orange on the button.
This button is also used to write shot
marks on the tape.
For details, see 5-2-2 "Writing Shot
Marks" (page 5-4).
5 IN/OUT (IN point/OUT point)
buttons
Press these buttons, lighting them,
together with the ENTRY/SHIFT
button 4 to set an IN point (edit start
point) or OUT point (end point). After
setting edit points, you can press these
buttons to display the edit points in the
submenu screen.
6 REVIEW button
After executing an automatic edit,
press this button, lighting it to review
the results of the edit.
7 AUTO EDIT button
After setting edit points, press this
button, lighting it to execute an
automatic edit (record to the recorder
unit). If an IN point has not been set,
the point where you press this button
is used as the IN point in the
automatic edit. This button lights
during execution and goes out when
execution finishes.
Pressing this button when the unit is in
DMC edit mode executes a DMC edit.
To conduct DMC editing, a playback
speed must be set in advance. For
details, see 3-5"DMC Editing" (page
3-14).
8 PREVIEW button
Press this button, lighting it, when you
want to preview editing results on the
monitor after setting edit points but
before executing an edit, or when you
want to set the playback speed for
DMC editing. If an IN point has not
been set, the point where you press
this button is used as the IN point in
the preview. This button lights during
the preview and goes out when the
preview finishes.
1-15
Overview
Advertisement
Table of Contents
