Table of Contents
Advertisement
2-7 Input and Output Settings for Video and Audio
Signals (Submenu)
Contents of the audio settings subpages
When you change the settings of the
audio settings subpages, the settings of
the AU-1 group pages change as well,
and vice versa.
However, when there is no item in the
subpages corresponding to a setting
made in an AU-1 group page, the
setting is not reflected in the subpages.
Input mixing settings page
By pressing operation buttons F1 to
F3, you can make the following three
settings for mixing of input signals in
audio channels 1 and 2. The selected
setting is highlighted. To select input
signals, use audio settings page 1-1.
MIX OFF: Assign IN-1 to channel
1, and assign IN-2 to channel 2.
1+2 t 1: Assign mixed signals of
IN-1 and IN-2 to channel 1, and
assign IN-2 to channel 2.
1+2 t 2: Assign IN-1 to channel 1,
and assign mixed signals of IN-1
and IN-2 to channel 2.
2-28
Preparations
Output monitor settings page
Note
When WID/MON on general settings
page 2/2 is set to AU.MON, you
cannot display this page. To make
monitor output settings, use the
WIDE/AU.MON switch (see page 1-
5) on the display panel.
By pressing operation buttons F1 to
F3, you can make the following three
settings for left and right monitor
output signals. The selected setting is
highlighted.
L/R=1/2: Assign channel 1 to
monitor output L (left), and
assign channel 2 to monitor
output R (right).
1 y 2: Assign channel 2 to monitor
output L, and assign channel 1 to
monitor output R.
1+2: Assign mixed signals from
channels 1 and 2 to monitor
output L and R.
Advertisement
Table of Contents
