Table of Contents
Advertisement
6-2 Basic Menu
Item number
Item name
001
PREROLL TIME
a)
002
CHARACTER
H-POSITION
003
a),b)
CHARACTER
V-POSITION
004
SYNCHRONIZE
a) When setting items 002, 003, 009, and 011,
watch the monitor screen, and adjust to the
required state.
b) When displaying time code values, there is
a slight time delay. Therefore, when
creating a tape for off-line editing, the
information inserted in the upper half of the
screen may be delayed by one frame.
6-2
Setup Menu
Settings
0S... 5S ...30S: Set the preroll time to between 0
and 30 seconds in steps of 1 second. A preroll time
of at least 5 seconds is recommended when using
this unit for editing.
Adjust the horizontal position (a hexadecimal value)
of the character information which is output from the
VIDEO OUTPUT 2 (SUPER) connector and the
character information which is displayed on the
LCD monitor.
00... 27 ...46 (525 mode, 71 steps)/00... 20 ...43
(625 mode, 68 steps): The hexadecimal value 00 is
for the far left of the screen. Increasing the value
moves the position of the characters to the right.
Adjust the vertical position (a hexadecimal value) of
the character information which is output from the
VIDEO OUTPUT 2 (SUPER) connector and the
character information which is displayed on the
LCD monitor.
00... 57 ...6C (525 mode, 109 steps)/00... 5D ...75
(625 mode, 118 steps): The hexadecimal value 00
is for the top of the screen. Increasing the value
lowers the position of the characters.
When editing using this unit as a controller and an
external VTR connected to this unit via a 9-pin
remote control cable, this item determines whether
or not to operate the two units in phase
synchronization.
ON : Operate in phase synchronization.
OFF: Do not operate in phase synchronization.
Advertisement
Table of Contents
