Table of Contents
Advertisement
Combining Two VTRs
This section describes how to combine
two DNW-A25WS/A25WSP units
using the BKNW-225, and how to
separate the combined units.
For details of the BKNW-225, refer to
the BKNW-225 Operation Guide.
Caution
Use only the supplied screws.
If you use any screws other than the
supplied screws, there is a danger of
electric shock.
Notes
• Make sure the screws are firmly
fastened.
Otherwise, there is a danger of
dropping the units while carrying it,
which may result in injury.
• When combining two DNW-
A25WS/A25WSP units, be sure to
replace the handles supplied with
them by the handle supplied with the
BKNW-225. Using the handles
supplied with the DNW-A25WS/
A25WSP units may result in
dropping the units, and possible
injury.
A-16
Appendixes
To combine two DNW-A25WS/
A25WSP units, proceed as follows.
1
Remove the handles from both of
the DNW-A25WS/A25WSP
units.
Handles
2
Place both units in horizontal
position as shown below, and
attach the three coupling plates
using four screws for each plate.
Recorder
Coupling plates
Player
Advertisement
Table of Contents
