Table of Contents
Advertisement
When set to CPSTALL
Output to
LCD monitor
Time data
No
Menus
No
Error
No
messages/
Shot Mark
list
For details about the information
displayed, see "To display
superimposed text information" (page
A-11).
2 CAPSTAN (capstan lock) setting
Set the capstan servo lock mode.
2F: Lock the capstan servo on 2
fields. When performing picture
shift under the 525 system, set
setup menu item 712 to ON (see
page 6-28).
4F: Lock the capstan servo on 4
fields.
8F: Lock the capstan servo on 8
fields (625 system only).
3 DF/NDF setting (in 525 mode)
Select DF to advance timecode in
drop-frame mode, and NDF to
advance timecode in non-drop frame
mode.
4 BACKLGT (back light) setting
Set to HIGH to increase the brightness
of the LCD monitor back light.
5 KEY INH (key inhibit) setting
Set to ON to disable the buttons on the
Output to
control panel. (Submenu operations
VIDEO OUT
can still be performed even when this
2 (SUPER)
connector
item is set to ON.)
You can select the buttons that are
Yes
disabled under setup menu item 118
Yes
(see page 6-12).
Yes
If you try to operate the disabled
buttons, the message "!!KEY INH.!"
appears in the time data display area in
the submenu screen.
6 BAT-END (battery end) setting
Set a voltage value to indicate the
shutdown voltage of this unit
depending on the batteries you are
using.
7 BAT-NE (battery near end)
setting
For alarms that alert you when the end
of power as specified in the battery
end setting 6 is near, specify a
voltage that at which to begin the
alarm display.
8 VFDBRIT (submenu brightness)
setting
Sets the brightness of the submenu
screen to HIGH or LOW.
2-33
Preparations
Advertisement
Table of Contents
