Table of Contents
Advertisement
Item
Setting
VID SG
Select the test signal to be output from the VTR's internal test signal
generator.
The internal test signal generator operates and outputs the selected test
signal. This signal can also be recorded.
CB75 : 75% color bar signal
CB75R: 75% color bar signal (reverse)
CB100 : 100% color bar signal
BOW: Bowtie signal
PLSBR: Pulse & bar signal
MLTBS: Multi-burst signal
HSWP: H sweep signal
5STEP: 5-step signal
RAMP: Ramp signal
SH: Shallow ramp signal
RED: Red signal
GRAY: 50% flat signal
WHITE: 100% flat signal
SDI: SDI check field signal
NTC7: NTC 7 test signal (selectable only in 525 mode)
LN330: Line 330 test signal (selectable only in 625 mode)
BB: Black burst signal
WIDE
Selects the aspect ratio for playback video signals or input video signals
displayed on the LCD monitor.
EDGE: Aspect ratio 16:9 (edge crop mode)
L.BOX: Aspect ratio 16:9 (letter box mode)
OFF: Aspect ratio 4:3
Note
The WIDE item does not appear when WID/MON on general settings page
2/2 is set to WIDE (see page 2-34) . In this case, select the aspect ratio by
using the WIDE/AU.MON switch (see page 1-5) on the display panel.
2-31
Preparations
Advertisement
Table of Contents
