Table of Contents
Advertisement
2 INT/EXT (internal/external
timecode) switch
Selects the timecode to use.
INT: Use the timecode generated by
this unit's built-in timecode
generator.
EXT: Use external timecode. When
the VITC/LTC/AUTO item of
the submenu is set to LTC or
AUTO, the external timecode
input to the TC IN connector.
When it is set to VITC, the VITC
of input video signal.
For more information about the VITC/
LTC/AUTO settings, see page 2-21.
3 PRESET/REGEN (regenerate)
switch
Selects the value set in the internal
timecode generator.
PRESET: Preset the initial value of
the timecode generated by the
internal timecode generator,
either by a control panel
operation or by remote control
from the device connected to the
REMOTE connector.
REGEN: Synchronize the internal
timecode generator with the
timecode read by the internal
timecode reader.
4 F-RUN/R-RUN (free-run, rec-
run) switch
Selects the progression method for the
timecode generated by the internal
timecode generator.
F-RUN: Timecode progresses
continuously from the time when
this unit is powered on,
regardless of the unit's operating
status.
R-RUN: Timecode progresses only
during recording.
When you use this switch, set the INT/
EXT switch 2 to INT, and set the
PRESET/REGEN switch 3 to
PRESET.
5 Monitor output switch
Selects the output signals from the
VIDEO and AUDIO OUTPUT
connectors during fast forward,
rewind, stop, and standby mode.
PB: Playback (PB) mode
PB/EE: E-E mode
6 MENU button
Use for setup menu operations. The
setup menu appears on the LCD
monitor when you press this button,
and the original display appears when
you press it again.
For more information about setup
menu operations, see Chapter 6,
"Setup Menu".
7 SET button
Use to make setup menu settings,
timecode settings, and user bit
settings.
For more information about setup
menu operations, see Chapter 6,
"Setup Menu". For more information
about timecode and user bit settings,
see 2-5 "Setting Timecode" (page 2-
13).
1-13
Overview
Advertisement
Table of Contents
