Table of Contents
Advertisement
4 AUDIO OUTPUT CH-1/3 and
CH-2/4 connectors (XLR 3-pin,
male)
Output the audio signals of the
channels selected with the LINE OUT
in the submenu. You can select two
combinations of output signals:
channels 1 and 2, or channels 3 and 4.
For more information about LINE
OUT settings, see page 2-26.
Note
The level can be adjusted from the
control panel, but mixed signals
cannot be output.
5 MONITOR OUTPUT L/R
connectors (XLR 3-pin, male)
Output the audio signals of the
channels selected with the MONITOR
L/R in the submenu. The level is
adjustable, and mixing is possible.
Connect these connectors when you
want to output mixed signals.
For more information about
MONITOR L/R settings, see page
2-26.
You can also adjust the output level of
the LEVEL knob in the front panel
controls section with the MONITOR in
the submenu. For details, see page 2-
26.
6 REF. VIDEO IN (reference
video signal input) connectors (BNC
type) and 75 Ω termination switch
Input a video signal with color burst
(VBS) or monochrome video signal
(VS) as reference video signal. Set the
75 Ω termination switch to OFF when
the signal is bridged, and to ON when
the signal is not bridged.
7 VIDEO INPUT (analog
composite video input) connectors
(BNC type) and 75 Ω termination
switch
Input an analog composite video
signal. Set the 75 Ω termination
switch to OFF when the signal is
bridged, and to ON when the signal is
not bridged.
8 VIDEO OUTPUT (analog
composite video output) connectors
(BNC type)
Output analog composite video
signals. When the SUPER in the
submenu is set to ALL or CPSTALL,
timecode, menu settings, error
messages and other information is
superimposed on the output of
connector 2 (SUPER).
For more information about SUPER
settings, see page 2-32. For details
about the superimposed information,
see page A-11.
1-21
Overview
Advertisement
Table of Contents
