Removing The Scnt Unit - Canon MF8100 Series Service Manual

Chapter 3
[1]
[2]
2) Open the board unit; then, disconnect the 6 connectors [1] and the 3 flat
cables [2].
[1]

3.2.11.4 Removing the SCNT Unit

1) Remove the two screws [1], and detach the support plate [2].
[1]
[2]
2) Remove the 2 screws [1], and detach the modular board cover [2].
[2]
[1]
MEMO:
Pay attention to the harness [3], as it is connected to the cover..
3) Remove the 4 screws [1], and open the NCU unit [2].
3-20
[1]
[1]
F-3-120
[2]
[1] [2]
F-3-121
[1]
[2]
F-3-122
[3]
F-3-123
[1]
4) Disconnect the flat cable [1] and the connector [2].
5) Remove the screw [1], and disconnect the connector [2].
0012-7165
6) Remove the screw [1], and detach the retainer [2].
7) Disconnect the connector [1] and remove the lithium board [2].
8) Remove the screw [1], and detach the two cable retainers [2].
[1]
[2]
F-3-124
[1]
[2]
F-3-125
[2] [1]
F-3-126
[1] [2]
F-3-127
[2] [1]
F-3-128