Chapter 3
[1]
3.2.13.3 Removing the Modular Board Cover
1) Remove the 2 screws [1], and detach the modular board cover [2].
[2]
[1]
Pay attention to the harness [3].
3.2.13.4 Removing the NCU Board
1) Remove the 4 screws [1], and open the NCU unit [2].
[1]
[2]
2) Disconnect the flat cable [1] and the 2 connectors [2]; then, remove the 4
screws [3], and detach the NCU board [4].
[4]
[2]
3.2.14 Modular Board
3.2.14.1 Removing the Rear Cover
1) Disconnect the cable [1] of the power supply assembly.
2) Open the face-up cover [2], and remove the 4 screws [3] of the rear cover.
3-26
[2]
F-3-162
[3]
F-3-163
[1]
F-3-164
[3]
[1]
[2]
[3]
F-3-165
[3]
3) Open the reader assembly [4], and lift to free the 2 claws [5].
0007-8070
4) Close the reader assembly; then, detach the rear cover[1].
0007-8068
[3]
F-3-168
3.2.14.2 Removing the Scanner Unit
1) Remove the platen glass cover.
2) While removing the left and right claws, detach the hinge cover [1].
3) Remove the screw [2], and detach the cable guide [3].
4) Open the harness band [1], and free the 2 cables [2] connected to the
reader assembly.
0007-8061
[1]
[2]
F-3-166
[5]
F-3-167
[1]
[3]
[2]
[1]
[3]
[2]
F-3-169
[3]
[4]
0007-8064