Removing The Right Frame; Removing The Registration Clutch; Removing The Main Drive Assembly - Canon MF8100 Series Service Manual

[1]
Enlarged View of the Paper Retainer
OK
[3]
When attaching the top cover, be sure to fit the link lever [2] while keeping
the drive release lever [1] in up position (i.e., with drive disengaged).
If you are fitting the drum cartridge in the machine with the top cover re-
moved, be sure to do so with the drive release lever [1] fully in up position
(i.e., with drive disengaged).
If the drive release lever is in low position (i.e., with drive engaged), it forces
out the coupling [2], causing the coupling to interface with the drum car-
tridge and to suffer damage.
[2]
F-3-762
NG
[3]
F-3-763
[2] [1]
F-3-764

3.5.11.8 Removing the Right Frame

1) Remove the 5 screws [1], and detach the right frame [2].
[2]

3.5.11.9 Removing the Registration Clutch

1) Disconnect the connector [1], and open the harness band [2].
2) Remove the E-ring [3], and detach the registration clutch [4].
[4] [2]
The connector on the registration clutch side is designed to prevent discon-
nection. If you have to detach the registration clutch, be sure to disconnect
the connector (J113) on the DC controller PCB side.

3.5.11.10 Removing the Main Drive Assembly

1) Shift down the drive release lever [1], and remove the gear [2].
Chapter 3
[1]
[2]
F-3-765
[1]
[1]
F-3-766
[3] [1]
F-3-767
0011-6601
0007-8826
0007-8832
3-117