Removing The Right Frame; Removing The Shield Plate; Removing The Inside Cover; Removing The Registration Clutch - Canon MF8100 Series Service Manual

Chapter 3

3.6.7.8 Removing the Right Frame

1) Remove the 5 screws [1], and detach the right frame [2].
[2]

3.6.7.9 Removing the Shield Plate

1) Free the flat cable [1] from the connector.
2) Remove the 6 screws [2], and detach the shielding plate [3].
[2]

3.6.7.10 Removing the Inside Cover

1) Remove the 2 claws [1], and detach the inside cover [2].
[2]
3-142
[1]
[2]
F-3-921
[1]
[1]
F-3-922
[3]
[1]
[2]
F-3-923
[1]
F-3-924

3.6.7.11 Removing the Registration Clutch

1) Disconnect the connector [1], and open the harness band [2].
2) Remove the E-ring [3], and detach the registration clutch [4].
The connector on the registration clutch side is designed to prevent discon-
nection. If you have to detach the registration clutch, be sure to disconnect
0011-6605
the connector (J113) on the DC controller PCB side.

3.6.7.12 Removing the Main Drive Assembly

1) Shift down the drive release lever [1], and remove the gear [2].
2) Remove the 2 screws [1], and detach the front sub cover [2].
0011-6586
[2]
When mounting the main drive assembly, be sure to fit the gear [2] as shown
with the drive release lever [1] in down position (i.e., with drive engaged).
0007-7118 At this time, be sure that the position of the gear is correct so that it is fully
engaged with the gear of the drive release lever.
[4] [2] [3] [1]
F-3-925
[1]
[2]
F-3-926
[1]
F-3-927
F-3-928
0007-7125
0007-9072
[2]
[1]