Specifications - Isolated Digital Input/Output Module; Ht 00268 Opt-A1 - Hatteland HD 12T21 User Manual

Specifications - Isolated Digital Input/Output Module

DATA SHEET
Manufacturer:
Product:
Typenumber:
Isolated Digital IO module (4 x Output + 4 x Input)
Description:
The Hatteland Display DIO modules provide the system with 4 isolated digital output and 4 isolated digital input. The module is attached
to the motherboard via USB interface. Application software access the DIO channels via D2XX interface provided by the chip
manufacturer, i.e. in the normal case is there no requirements for low level software development. This module will mainly be
integrated, electrical and mechanical, in the final products, such as; Series X 12, 13, 15, 17, 19, 24, 26 inch Panel Computers and
selected Stand-alone Computers.
Digital Output
• Features
• Maximum Ratings
• Typical Application - Low Power control / relay control.
Digital Input
• Features
• Maximum Ratings - Input voltage 8-36V.
Dimensions might be shown with or without decimals and indicated as mm [inches]. Tolerance on drawings is +/- 1mm. For accurate measurements, check relevant DWG fi le.

HT 00268 OPT-A1

IND100129-169
This information may not, in whole or in part, be copied, photocopied,
reproduced, translated or reduced to any electronic medium or machine-
readable form without the prior written consent of Hatteland Display AS.
The products may not be copied or duplicated in any way.
Hatteland Display AS
Isolated Digital IO module (4 x Output + 4 x Input)
HT 00268 OPT-A1
- 4 x independent output channels, High side switch.
- Outputs are short circuits and overload protected.
- Thermal shutdown.
- Isolated towards chassis.
- Output status/diagnostic feedback available for each output channel.
- Outputs is rated for inductive and resistive loads.
- Outputs is rated for driving small motors.
- Classified towards IEC60945 and IEC60950.
- Voltage: 9-36V continuously.
- Load Current: 0.5A up to 32V, 0.3A up to 36V.
- Response time hardware for change of output state <20ms.
- Response time hardware for diagnostic feedback <30ms.*
- Worst case short circuit current (each channel) < 1.5A.
*Typical response time at system level: 200ms.
- Medium power buzzer.
- Indicator/signal lamps.
- 4 x independent input channels.
- Fully isolated towards chassis and channel to channel.
- Short circuit and reverse voltage protected.
- Classified towards IEC60945 and IEC60950.
- Response time hardware <10ms.
- Input current < 20mA.
Hatteland Display AS, Åmsosen, N-5578 Nedre Vats, Norway
Tel: (+47) 4814 2200 - mail@hatteland-display.com - www.hatteland-display.com
All specifications are subject to change without prior notice!
Last Revised:
Revision#:
Above: High side switch concept
49
18 Apr 2013
02
Application Circuit
Application Circuits
1/2