Table of Contents
Advertisement
Installation Procedures
Note: Some units may have Single Key Hole, whilst others have Double Key Hole
(Point 5, FIG2/3 in table below) present in the chassis side. This is due to slight variation
in initial production vs Mass Production throughout 2012/2013. During early/mid 2013,
all units will feature Double Key Hole. Illustration to the right shows Single Key and
Double Key cut-out.
Caution:
Single Key hole units does not support ceiling mount. Double Key Hole supports ceiling mount of unit.
▼ 5: Ensure that both Key Hole Plugs slide into the Key Holes and goes to the bottom position (FIG1 and FIG2). If they appear
too tight, you may loose the Key Hole Plug screw a few turns and re-try (see previous step 2). FIG3 shows Key Hole Plug cor-
rectly into Key Hole and both brackets in place.
FIG1
▼ 6: Tighten Key Hole Screw firmly on each side and
make sure the brackets are properly mounted and
aligned to the main chassis of unit. Verify with your
hands that both brackets are firmly attached.
(BRD version only, not present on TMB version).
▼ 8: You may now mount the unit onto your desired location. It is advised that you unlock the Lock Pin (as shown in step 7), tilt
the unit 90 degrees backwards (FIG1) and properly fasten the bracket base into location (FIG2). NB! Be careful not to break
or scratch the edge of the front glass! Then repeat step 7 again until your desired tilting position has been achieved and you
have verified that the Lock Pin are in locking position and the unit is firmly attached and does not appear loose (FIG3).
FIG1
Unlock, tilt and lock
Installation
IND100078-34
FIG2
▼ 7: While unit is lying flat on table, check the Tilting Lock Pin
position. These can be pulled out by hand, turned 90° (FIG1) and
turned back 90° until the Lock Pin automatically clicks into place by a
spring (FIG2).
FIG1
FIG2
Use appropriate fasteners
6 pcs x M6 needed
29
FIG3
Top View
Re-check Lock Pins!
2012 / 2013
2013
FIG3
FIG2
Locked
Unlocked
FIG3
Advertisement
Table of Contents
