Basic Configuration using phone keypad
You will need admin privilege to perform this and other configurations. By default the
phone will be in user mode, so you will need to perform a simple procedure to switch to
admin mode. Phone will return to user mode after reboot.
Change phone to admin mode: Press MENU 7.User type. Press right navigation
key until you see "admin" on the screen. Then press the down key to be prompted for
the password. It is "admin" by default. Type it and press OK.
Network Settings: Press MENU->3.Settings->2.Advanced->OK. Enter the admin
password, and choose Network->WAN Port/PC Port /VLAN/Web Type/802.1x
Settings to enter the internet relating configuration page.
Account Settings: Press MENU->3.Settings->2.Advanced->OK. Enter the admin
password, and choose Accounts->OK to configure the account settings.
You can refer to the above "Configuring via Web Page" for parameter details.
Note:
The active User Type is shown with an * on the left of display when you enter Menu
7.
User Type menu, like this:
<*user
>
Once you finish all admin related tasks you should go back to user mode with the same
procedure, or simply reboot the phone.
Temporis IP 200 Administrator Guide
ed 1.0
- 12 - / 109